Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
51 31... Removing And Installing/Replacing Retaining Strip For Cowl Panel Cover
Necessary preliminary tasks:
- Remove cover for cowl panel
Retaining strip (2) has an aluminum profile insert (1).
Carefully wind out retaining strip (2) (windscreen breakage).
- Glue bead
- Pinched butyl
- Contact surfaces
Installation:
Clean cutout.
Pay attention to center marking on retaining strip (1) and windscreen.
Insert positioner (2) for retaining strip (1) must be removed after it has been fitted on the windscreen but before the windscreen itself is installed.
Replacement of retaining strip without windscreen removal:
If adhesive has managed to get onto retaining strip (1), this area must be cut out partially.
To facilitate installation, coat and body cutout with water.
Replacement of retaining strip with removed or new windscreen:
Fit rubber frame (1).
- Aluminum strip
- Contact surfaces
- Butyl
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.