Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Adhesive Quantities: Notes
Approx. 1 1/4 adhesive cartridges are required to cement the windscreen on the following vehicles:
- 7 Series
- 5 Series from E60
- X5
- X3
In the case of hot cementing (with accelerator), the missing residual bead is applied from a second adhesive cartridge (not contained in the repair kit) but while cold and without accelerator (bubbling).
Minimum hardening period is thus not increased.
- First apply cold adhesive to cowl panel at bottom (skin formation time)
- Accelerator from repair kit must not be used with the second cartridge (bubbling)
Bubbling results in leakage and insufficient bonding strength (torsional rigidity, passenger airbag).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.