Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
51 46... Removing And Installing/Replacing Upper Cross-Member Cover
Risk of injury!
There is a danger of trapping when working in the area of the convertible top system. Make sure convertible top is not actuated during work.
Necessary preliminary tasks:
- Removing air outlet grill
Move convertible top into position shown.
Lift clamping bracket and soft top compartment cover upright.
Release expansion rivets (1).
Release screws (2).
Raise panel for convertible top compartment (3) in covered area.
Feed out cross-member cover (4) towards top.
Installation:
Feed all screws/expander rivets onto cross-member cover (4).
Align cross-member cover (4) with rollover protection system and secure with screws/expander rivets.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.