24 00 032 Removing And Installing Automatic Transmission (GA6L45R)

2011 BMW 128i 2D Convertible, N51, StandardSECTION 24 00 032 Removing And Installing Automatic Transmission (GA6L45R)

Special tools required: 

IMPORTANT: After completion of work, check transmission oil level  . See 00 11 237 CHECKING/TOPPING UP FLUID LEVEL IN AUTOMATIC TRANSMISSION (GA6L45R) . Use only the approved transmission fluid. Failure to comply with this requirement will result in serious damage to the automatic transmission!
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.