Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2011128I 2D CONVERTIBLE, N51, STANDARDREPAIR AND DIAGNOSISELECTRICALGAUGESBODY EQUIPMENT - REPAIR (E88)FRONT AND REAR WINDOW51 31... REMOVING WINDSCREEN WITH "ROLL OUT 2000"PREPARATORY WORKNOTES
2011 BMW 128i 2D Convertible, N51, Standard
Preparatory Work: Notes
2011 BMW 128i 2D Convertible, N51, StandardSECTION Notes
- Cut off required length from cutting wire:
Window glass diagonal x 6
- The cutting wire loops must lie on top of each other in area (B).
They must not get caught up in each other. (Otherwise no possibility of cutting the adhesive bead/wire tears.)
Overlapping of cutting wire loops approx. 10 cm.
Distance from right window edge approx. 30 cm.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.