Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSBMW2011128I 2D CONVERTIBLE, N51, STANDARDREPAIR AND DIAGNOSISELECTRICALGAUGESBODY EQUIPMENT - REPAIR (E88)BMW EMBLEMS, MODEL EMBLEMS51 14 110 REMOVING AND INSTALLING/REPLACING REAR MODEL DESIGNATIONFITTING DIMENSIONS (E82/E88)NOTES

2011 BMW 128i 2D Convertible, N51, Standard

Fitting Dimensions (E82/E88): Notes

2011 BMW 128i 2D Convertible, N51, StandardSECTION Notes

Fig 1: Identifying Fitting Dimensions (E82/E88)

Courtesy of BMW OF NORTH AMERICA, INC.

Stick on adhesive tape (1) horizontally according to dimension "A".

Mark reference point (2) according to dimension "B".

Position model designation at reference point (2) and stick on.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.