Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2011128I 2D CONVERTIBLE, N51, AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSBODY EQUIPMENT - REPAIR (E88)FRONT BUMPER51 11... INSTALLING/REPLACING NUMBER/LICENSE PLATE (WITHOUT BASE)REPAIRING THREAD
2011 BMW 128i 2D Convertible, N51, Automatic
Repairing Thread
2011 BMW 128i 2D Convertible, N51, AutomaticSECTION Repairing Thread
Drill out defective hole in bumper (2) to 9.5 mm diameter.
Insert blind rivet nut (1)*.
Secure number/license plate (3) with number/license plate screw (4)*.
Tightening torque, see 51 11 4AZ in 51 11 FRONT BUMPER .
NOTE:
*Sourcing reference: BMW Parts Service
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.