Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2010X6 ACTIVEHYBRIDREPAIR AND DIAGNOSISBODY & FRAMESEATSGENERAL ELECTRICAL SYSTEM - REPAIRPLUG CONNECTION, TERMINALS, FUSE BOX61 13... RETAINING BRACKET
2010 BMW X6 ActiveHybrid
61 13... Retaining bracket
2010 BMW X6 ActiveHybridSECTION 61 13... Retaining bracket
Pull relevant fuse out of fuse block (1).
NOTE:
Mark positions when removing fuses.
Pull locking slide (2) out of fuse block (1) as far as it will go.
With special tool 61 1 136 or 61 1 137 (ejector), press back arrester hook (3) of appropriate contact and pull out cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.