Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 31 014 Removing And Installing/Replacing Start/Stop Switch
2010 BMW X5 35dSECTION 61 31 014 Removing And Installing/Replacing Start/Stop Switch
Necessary preliminary tasks:
- Remove decorative strip on instrument panel, driver's side, on right . See 51 45 374 REMOVING AND INSTALLING/REPLACING DECORATIVE STRIP ON INSTRUMENT PANEL ON DRIVER'S SIDE ON RIGHT .
Release screws (1).
Pull out Start/Stop switch (2) a little.
Disconnect plug connection (1).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.