Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
11 34 560 Replace all valve stem seals (M57T2-SCR)
Necessary preliminary work:
- Remove cylinder head. See 11 34 715 Replace all valve springs (M57T2- SCR) .
- Remove all valve springs. See 11 34 715 Replace all valve springs (M57T2- SCR) .
Press special tool 11 6 370 onto valve stem seal and turn.
Pull out special tool 11 6 370 together with valve stem seal.
Lubricate valve stem and fit special tool 11 1 960.
Coat new valve stem seal (1) with oil and install.
Detach special tool 11 1 960.
Press on valve stem seal with special tool 11 6 380 to the limit position.
Assemble engine.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.