Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2010X5 35DREPAIR AND DIAGNOSISENGINE MECHANICALMECHANICALENGINE - OPERATING FLUIDS
2010 BMW X5 35d
Engine - Operating Fluids
2010 BMW X5 35dSECTION Engine - Operating Fluids
- 1.0 General Information
- Notes
- Good Wear Protection and Friction Reduction
- Limited Tendency to Produce Combustion Residue
- Favorable Viscosity Temperature Behavior
- Anti-Foaming
- Good Corrosion Inhibition
- Mixing Ability/Compatibility
- Good Thermal Conductivity/Good Cooling Property
- Good Dispersant/Detergent Qualities
- Oxidation Inhibitors and Aging Stability
- 2.0 Grading Of Oils
- 3.0 Engine Oil Requirements and Specifications
- 4.0 Engine Oil Change Intervals
- 5.0 Condition Based Service
- 6.0 Engine Oil Additives
- 7.0 Break-In Instructions
- 8.0 N52, N52KP and N54 Front and Rear Radial Seal Sealant
- 10.0 Lubricant For Oxygen Sensor
- 11.0 Oil Consumption
- 13.0 Operating Fluids Table and Alternate Suppliers
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.