Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 67 100 Removing And Installing/Replacing High - Pressure Nozzle Of Headlight Washer System On Left (Or Right)
Special tools required:
- 00 9 340
Necessary preliminary tasks:
- Remove front bumper trim . See 51 11 156 REMOVING AND INSTALLING FRONT BUMPER TRIM .
Lever out cover (1) with special tool 00 9 340.
Slowly pull out spray nozzle (1) by cover (2).
Unclip cover (2) and remove.
Allow nozzle (1) to slide back slowly.
Pull back clasp (1) and disconnect plug connection (2).
Unlock catch (3) in direction of arrow.
Pull out high-pressure nozzle (4) towards rear.
Installation:
Make sure retaining lugs (3) engage correctly.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.