Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
32 00... Moving Vehicle Into Design Position
2010 BMW X5 30iSECTION 32 00... Moving Vehicle Into Design Position
Necessary preliminary tasks:
- Move vehicle into normal position . See 32 00... MOVING VEHICLE INTO NORMAL POSITION .
- Version with air spring system:
- Remove ignition key
- Pull fuse for air supply unit control unit
- Add/distribute weights in area of spring struts until the vehicle ride height is within the tolerance.
Measure ride-level height of vehicle . See 31 33 095 MEASURING RIDE-LEVEL HEIGHT OF VEHICLE .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.