Condition Actuator Reports System Error

2010 BMW M5 (E60) V10-5.0L (S85)SECTION Condition Actuator Reports System Error
2B15 - P0638

Information saved in
DME

Fault code
2B15 - P0638

Fault text
Throttle-valve actuator, governor monitoring, Bank 1

Fault description


Condition for fault identification
Test condition:
Communications and CAN OK
Terminal condition: Terminal 87
Voltage condition:
none

Condition for fault memory entry
Actuator reports system error

Action in service
1. Delete stored DTCs from error memory, conduct system
test for electromotive throttle-valve actuator
2. Check plugs and wiring harness for throttle-valve sensor 1
and electromotive throttle-valve actuator 1
3. Replace throttle-valve sensor 1 or Bank 1 electromotive
throttle-valve actuator

Fault effect and breakdown warning
Engine speed limited to 3500 rpm / Check Control message /
power reduction / MIL comes on after engine runs 2x

Driver information
Warning light:
29-Engine malfunction

Service instruction
none
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.