Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 35 107 Removing and installing or replacing junction box electronics
Necessary preliminary tasks:
- Partially remove POWER DISTRIBUTION BOX FOR PASSENGER COMPARTMENT
Release screws (1) on junction box electronics (2).
Tightening torque 61 14 2AZ.
Disconnect plug connection (1).
Pull junction box electronics (2) out of bracket.
Installation note:
Make sure junction box electronics and plug connections (1) are correctly seated.
Replacement:
Carry out VEHICLE PROGRAMMING/CODING .
Delete transport mode.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.