Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 35 285 Removing and Installing (Replacing) Light Module
Necessary preliminary tasks:
- Remove trim panel for pedal assembly . See 51 45 185 REMOVING AND INSTALLING/REPLACING PANEL FOR PEDALS
Unlock catch (1) and feed out/remove light module (2) in direction of arrow.
Installation:
Make sure light module (2) is correctly seated in mounting (3) and catch (1).
If necessary, unlock catch (1) and remove cover (2) from light module (3).
Installation:
Make sure cover (2) is correctly seated on light module (3).
Disconnect plug connection (1).
Replacement:
Carry out programming/coding . See VEHICLE PROGRAMMING AND CODING
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.