Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2010550I STANDARDREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSBODY EQUIPMENT - REPAIRFRONT BUMPER51 11 701 REPLACING LEFT OR RIGHT BRACKET FOR FRONT BUMPER
2010 BMW 550i Standard
51 11 701 Replacing left or right bracket for front bumper
2010 BMW 550i StandardSECTION 51 11 701 Replacing left or right bracket for front bumper
Necessary preliminary tasks:
- Remove FRONT BUMPER TRIM
Release screws (1).
Remove bracket (2) in direction of arrow, catch (3) must not be damaged in the process.
Installation:
Bracket for bumper must not be damaged.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.