Preconditions for activation

2010 BMW 528xi StandardSECTION Preconditions for activation

BMW Night Vision is operational from terminal R.

Press the BMW Night Vision button.

BMW Night Vision will switch on in the following conditions:

  • The rain-light sensor detects sufficient ambient light. Driving lights are off:

    BMW Night Vision is operational 2 seconds after the button is pressed. At the earliest 30 seconds after the vehicle is activated (navigation system booted). During these 2 seconds, a warning appears on the Control Display or Central Information Display.

  • The rain-light sensor detects insufficient ambient light. Driving lights are on:

    BMW Night Vision is operational immediately after the button is pressed.

  • The rain-light sensor detects insufficient ambient light. Driving lights are off. Road speed is less than 5 km/h (e.g. in dark driveways or garage entrances):

    BMW Night Vision is operational immediately after the button is pressed.

BMW Night Vision is not switched on in the following conditions:

  • The rain-light sensor detects insufficient ambient light. Driving lights are off. Road speed greater than 5 km/h at the same time.

    A corresponding warning appears on the Control Display or Central Information Display.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.