Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2010528I (E60) L6-3.0L (N52K)REPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONU CODE CHARTSU110C
2010 BMW 528i (E60) L6-3.0L (N52K)
U110C
2010 BMW 528i (E60) L6-3.0L (N52K)SECTION U110C
CD98 - U110C
Information saved in
DME
Fault code
CD98 - U110C
Fault text
Message (torque request DSC, B6)
Fault description
Lost Communication With Torque Request DSC
Condition for fault identification
Test condition:
Always active
Terminal condition: Terminal 15 ON
Voltage condition:
Voltage in onboard electrical system > 10 V
Condition for fault memory entry
800 ms
Action in service
Check CAN link between DSC and DME
Fault effect and breakdown warning
Driver information
Warning light:
none
Service instruction
none
Information saved in
DME
Fault code
CD98 - U110C
Fault text
Message (torque request DSC, B6)
Fault description
Lost Communication With Torque Request DSC
Condition for fault identification
Test condition:
Always active
Terminal condition: Terminal 15 ON
Voltage condition:
Voltage in onboard electrical system > 10 V
Condition for fault memory entry
800 ms
Action in service
Check CAN link between DSC and DME
Fault effect and breakdown warning
Driver information
Warning light:
none
Service instruction
none
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.