Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSBMW2010328I 2D CONVERTIBLE, N52, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSGENERAL ELECTRICAL SYSTEM - REPAIR - E92/E93PLUG CONNECTION, TERMINALS, FUSE BOX61 13 INSTALLING COMB CONNECTOR FOR RETROFITTING/REPAIRS

2010 BMW 328i 2D Convertible, N52, Standard

61 13 Installing comb connector for retrofitting/repairs

2010 BMW 328i 2D Convertible, N52, StandardSECTION 61 13 Installing comb connector for retrofitting/repairs

Special tools required:

61 9 040
61 9 041
61 9 042

NOTE: The repair range IV for vehicle electrical system contained the required special tools and individual parts for retrofitting and repair work with the aid of fan connectors.

The case can no longer be ordered.

Special tools:

special tool 61 9 040

Fig 1: Identifying Repair Kit
Courtesy of BMW OF NORTH AMERICA, INC.

Choose contact sleeve (up to 4 mm² ) in accordance with wire cross-section.

Fig 2: Identifying Contact Sleeve

G04753271

Courtesy of BMW OF NORTH AMERICA, INC.

Alternatively:

Choose contact sleeves (up to 2.5 mm² ) for fan connectors.

Fig 3: Identifying Contact Sleeves For Fan Connectors

G04753272

Courtesy of BMW OF NORTH AMERICA, INC.

Cut through wire loop in wiring harness at established point.

Strip insulation from both wire ends.

Refer to repair instructions:

Cutting To Length And Stripping Insulation From Cables

Fig 4: Identifying Special Tool

G04753273

Courtesy of BMW OF NORTH AMERICA, INC.

Crimp contact sleeves on both wire ends.

Refer to repair instructions:

Crimping On Stop Parts

Fig 5: Crimping Contact Sleeves On Wire Ends

G04753274

Courtesy of BMW OF NORTH AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.