Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2010128I 2D COUPE, N52, AUTOMATICREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSGENERAL ELECTRICAL SYSTEM - REPAIR (E82)SWITCH61 31 037 REMOVING AND INSTALLING/REPLACING LIGHT CONTROL UNIT
2010 BMW 128i 2D Coupe, N52, Automatic
61 31 037 Removing And Installing/Replacing Light Control Unit
2010 BMW 128i 2D Coupe, N52, AutomaticSECTION 61 31 037 Removing And Installing/Replacing Light Control Unit
Special Tools Required
Detach mucket (1) in area of trim (2) in direction of arrow.
Lever out trim (2) with special tool 00 9 317 at mounting points (3) and remove.
Installation:
Retaining lugs (1) on trim (2) must not be damaged.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.