Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2010128I 2D COUPE, N52, AUTOMATICREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSGENERAL ELECTRICAL SYSTEM - REPAIR (E82)CONTROL UNITS, MODULES61 35 001 REMOVING AND INSTALLING (REPLACING) TRAILER MODULE
2010 BMW 128i 2D Coupe, N52, Automatic
61 35 001 Removing And Installing (Replacing) Trailer Module
2010 BMW 128i 2D Coupe, N52, AutomaticSECTION 61 35 001 Removing And Installing (Replacing) Trailer Module
IMPORTANT:
Read and comply with notes on protection against electrostatic damage ( ESD protection)
.
Necessary preliminary tasks:
- Remove right luggage compartment wheel arch trim . See 51 47 161 REMOVING AND INSTALLING/REPLACING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM .
E88:
Remove cover for control units (1).
Disconnect plug connection (1).
Remove trailer module (2) in direction of arrow from device mounting (3).
Replacement:
Carry out vehicle programming/coding.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.