Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2010128I 2D CONVERTIBLE, N51, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (GENERAL ELECTRICAL SYSTEM - REPAIR (E82))PLUG CONNECTIONS, TERMINALS, POWER DISTRIBUTION BOX61 13... OPENING PLUG HOUSINGS AND REMOVING CONTACTS OF DIFFERENT PLUG SYSTEMS61 13... IN-LINE PLUGS, 6, 8-PIN, SYSTEM MQS
2010 BMW 128i 2D Convertible, N51, Automatic
61 13... In-Line Plugs, 6, 8-Pin, System MQS
2010 BMW 128i 2D Convertible, N51, AutomaticSECTION 61 13... In-Line Plugs, 6, 8-Pin, System MQS
WARNING: This page is about a different variant/trim than selected.
Press lock (1) in direction of arrow and slide plug forward.
Press locking hook (2) downward and slide lock (1) out.
Press down arrester hook (1) with screwdriver and pull out cable with contact towards rear.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.