SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2010128I 2D CONVERTIBLE, N51, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (GENERAL ELECTRICAL SYSTEM - REPAIR (E82))PLUG CONNECTIONS, TERMINALS, POWER DISTRIBUTION BOX61 13... OPENING PLUG HOUSINGS AND REMOVING CONTACTS OF DIFFERENT PLUG SYSTEMS61 13... CONNECTOR HOUSING, LCC CONTACT (LOAD CURRENT CONTACT)
2010 BMW 128i 2D Convertible, N51, Automatic

61 13... Connector Housing, LCC Contact (Load Current Contact)

2010 BMW 128i 2D Convertible, N51, AutomaticSECTION 61 13... Connector Housing, LCC Contact (Load Current Contact)
WARNING: This page is about a different variant/trim than selected.

Special tools required:  61 0 317

Socket housing:  Press lock (1) with suitable tool (2) in direction of arrow out of socket housing (3).

Fig 1: Identifying Lock And Socket Housing With Suitable Tool
G04727532Courtesy of BMW OF NORTH AMERICA, INC.

Pull lock (1) out of socket housing (2).

Fig 2: Identifying Lock And Socket Housing
G04727533Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool 61 0 317 into socket housing (1) and pull out wiring with LCC contact (2) in direction of arrow.

Fig 3: Identifying Socket Housing And LCC Contact With Special Tools
G04727534Courtesy of BMW OF NORTH AMERICA, INC.

Pin housing: Unlock locking slide (1) of pin housing (2) with suitable tool (3) in direction of arrow.

Fig 4: Identifying Locking Slide, Pin Housing With Suitable Tool
G04727535Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool 61 0 317 into pin housing (1) and pull out wiring with LCC contact (2) in direction of arrow.

Fig 5: Identifying Pin Housing And LCC Contact With Special Tools
G04727536Courtesy of BMW OF NORTH AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.