61 35 950 Removing And Installing (Replacing) Control Unit For Comfort Access System

2010 BMW 128i 2D Convertible, N51, AutomaticSECTION 61 35 950 Removing And Installing (Replacing) Control Unit For Comfort Access System
WARNING: This page is about a different variant/trim than selected.
IMPORTANT: Read and comply with notes on protection against electrostatic damage ESD   protection)  .

Necessary preliminary tasks: 

Disconnect plug connection (1).

Remove control unit for comfort access system (2) in direction of arrow out of device mount (3).

Fig 1: Disconnecting Plug Connection
G05780056Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: 

Carry out vehicle programming/coding. 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.