Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
32 90... Troubleshooting on steering
2009 BMW X6 50iSECTION 32 90... Troubleshooting on steering
Observe TROUBLESHOOTING ON FRONT AXLE AND DIAGNOSIS HELP FOR STEERING (SI) .
TROUBLESHOOTING CHART
| Fault | Cause | Remedy |
|---|---|---|
| Steering wheel play too high | Screws at lower section of steering spindle to steering gear/steering spindle middle section loose | Replace screws and tighten down (refer to REMOVING AND INSTALLING/REPLACING LOWER SECTION OF STEERING SPINDLE ) |
| Screws at steering spindle middle section to steering spindle lower section/steering column loose | Replace screws and tighten down (refer to REMOVING AND INSTALLING/REPLACING LOWER SECTION OF STEERING SPINDLE for N54, and REMOVING AND INSTALLING/REPLACING STEERING SPINDLE LOWER SECTION (N63) for N63.) | |
| Journal of tie rod end deformed |
|
|
| Tie rod end worn | Check tie rods, replace if necessary | |
| Replace TIE ROD END | ||
| Steering gear rack damaged | Replace STEERING GEAR | |
| refer to TROUBLESHOOTING ON FRONT AXLE | ||
| Steering wheel inclination | Refer to BMW diagnosis system "Troubleshooting tree wheel/chassis alignment check" | |
| Refer to TROUBLESHOOTING ON FRONT AXLE | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.