Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 31 014 Removing and installing/replacing Start/Stop switch
- Check both sides of plug connection of ribbon cable (2) to slide-in unit for radio-operated key (1) for correct locking (3).
- Check ribbon cable (4) for damage.
If required, lock plug connection of ribbon cable (2) correctly and carry out function check. If this rectifies fault pattern, do not replace slide-in unit for radio-operated key.
Necessary preliminary tasks:
- Remove decorative strip on instrument panel, driver's side, on right . See 51 45 374 REMOVING AND INSTALLING/REPLACING DECORATIVE STRIP ON INSTRUMENT PANEL ON DRIVER'S SIDE ON RIGHT .
Release screws (1).
Pull Start/Stop switch (2) forward a little.
Disconnect plug connections (1) and remove Start/Stop switch.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.