Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSBMW2009X6 35IREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 18 (ENGINE CONTROLS - BASIC TESTING)FUEL SYSTEMFUEL PRESSURENOTES
2009 BMW X6 35i
Fuel Pressure: Notes
2009 BMW X6 35iSECTION Notes
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 1997 BMW Z3, 1997 BMW M3, 1997 BMW 840Ci, 1997 BMW 740iL, and 1997 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
Begin basic fuel system diagnosis by determining fuel system pressure.
- Remove engine cover to gain access to fuel lines. Connect Pressure Gauge (133060) and "T" Fitting (133064) in fuel lines in front of fuel pressure regulator. Block (plug) fuel return line with Fuel Hose Clamp (133010).
- Remove fuel pump relay. See DME & FUEL PUMP RELAY LOCATION table. Using Fuel Pump Relay Bridging Caliper (613050) or jumper wire, connect terminals No. 87 and 30 at fuel pump relay socket. See Figure . This will turn fuel pump on.
- Disconnect fuel return line. Install extension hose and hold end of hose in Graduated Glass Container (133020). Check fuel pump delivery rate. See FUEL PUMP PERFORMANCE table.
FUEL PUMP PERFORMANCE
| Application | Pressure psi (kg/cm2 ) | Min. Vol. In 30 Sec. Pts. (L) |
|---|---|---|
| All Models | 43 | 1.85 (0.9) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.