Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
86 21 ... Removing Gas Spring Retaining Bracket
Remove gas spring, refer to 86 21 ... REMOVING GAS SPRING .
Remove ball pivot, refer to 86 21 ... REMOVING BALL PIVOT .
Release screws (1) and remove gas spring retaining bracket (2) from mounting bracket (3).
Installation:
Install retaining bracket so that it is centered in elongated holes.
Tightening Torque, refer to 86 21 HOOD .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.