Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 35 795 Removing and installing (replacing) control unit for adaptive headlight
Necessary preliminary tasks:
- Remove right glovebox with housing, see 51 16 366 REMOVING AND INSTALLING RIGHT GLOVEBOX WITH HOUSING
Unlock catch (1) in direction of arrow.
Pull control unit for adaptive headlight (2) out of equipment carrier (3) slightly.
Unlock plug connection (4) and disconnect.
Remove control unit for adaptive headlight (2).
Replacement:
Carry out programming/coding, see Vehicle programming and coding .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.