Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2009550I STANDARD, GS653BZREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSBODY EQUIPMENT - REPAIRGENERAL51 00...NOTES ON COMPONENT BONDING ADHESIVE TAPE
2009 BMW 550i Standard, GS653BZ
51 00...Notes on component bonding adhesive tape
2009 BMW 550i Standard, GS653BZSECTION 51 00...Notes on component bonding adhesive tape
- General notes
- Bonding at room and object temperature of 18 to 25°C.
- Newly painted parts may only be bonded after a drying time of at least 24 hours.
- Optimal bonding/attachment to the background surface is achieved after approx. 48 hours. Components must not be exposed to mechanical strain beforehand (car wash, strength test, etc.).
- Do not touch bonding area.
- It is not the length of time that pressure is applied but rather the level of pressure applied that is crucial.
- Detaching the adhesive tape after pressing destroys the adhesive layer.
- After being pressed on gently, adhesive tape can be pulled off again up to 3 times.
- Auxiliary materials and tools
- CLEANING AGENT R1 OR CLEANING AGENT R2
- Fluff-free cleaning cloths
- Pressure roller
- Preparations
- Remove all remnants of adhesive or clean new part thoroughly
- Clean the areas to be bonded immediately before bonding to remove silicone and grease residues.
NOTE: Observe ventilation time ≥ 1 minute. - Bonding
- 4.1 Components without pre-fitted adhesive tape
- Pull off liner* from adhesive tape
- Position adhesive tape on component and stick on
- Press down adhesive tape over entire bonding area
- Continue with Point 4.2
* Liner is the protective film on the adhesive tape
- 4.2 Components with pre-fitted adhesive tape
- Pull off liner* from adhesive side (if bonding area is large, do not pull off liner completely)
- Align component in correct position on vehicle
- Press down component over entire bonding area
* Liner is the protective film on the adhesive tape
- 4.1 Components without pre-fitted adhesive tape
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.