Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Variant Code Identification and Display
The variant code for a DME M1. X control module can be displayed in three places.
- Electronically displayed
- Control module Identification page of the DIS or MoDiC diagnosis software.
- Programming software display with MoDiC. In the "adopt code" function, installed variant code is displayed.
- DME control module variant code label.
The control module ID page of the DIS is the quickest method of viewing the installed variant code. Electronic display is also the most accurate (code determination by the label could be a incorrectly written or accidentally placed on the wrong control module.)
Cross reference the BMW and Bosch part numbers in the display with the installed variant code. The correct variant code installed in the wrong control module, or an incorrect variant code installed in the correct control module, will undoubtedly cause control module malfunction.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.