Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2009128I CONVERTIBLE (E88) L6-3.0L (N52K)REPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONP CODE CHARTSP151C
2009 BMW 128i Convertible (E88) L6-3.0L (N52K)
P151C
2009 BMW 128i Convertible (E88) L6-3.0L (N52K)SECTION P151C
2E8D - P151C
Information saved in
DME
Fault code
2E8D - P151C
Fault text
Intelligent battery sensor, function
Fault description
Battery Sensor System Error
Condition for fault identification
Test condition:
IBS system fault
Terminal condition: none
Voltage condition:
none
Condition for fault memory entry
10 sec.
Action in service
Replace battery sensor
Fault effect and breakdown warning
Driver information
Warning light:
No warning lamp or CC status report
Service instruction
none
Information saved in
DME
Fault code
2E8D - P151C
Fault text
Intelligent battery sensor, function
Fault description
Battery Sensor System Error
Condition for fault identification
Test condition:
IBS system fault
Terminal condition: none
Voltage condition:
none
Condition for fault memory entry
10 sec.
Action in service
Replace battery sensor
Fault effect and breakdown warning
Driver information
Warning light:
No warning lamp or CC status report
Service instruction
none
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.