Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2008M5 (E60) V10-5.0L (S85)REPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWIPER MOTORSERVICE AND REPAIR
2008 BMW M5 (E60) V10-5.0L (S85)
Wiper Motor: Service and Repair
2008 BMW M5 (E60) V10-5.0L (S85)SECTION Service and Repair
61 61 270 - Removing and installing console for windshield wiper system completely with motor
Necessary preliminary tasks:
- Remove cowl panel cover Service and Repair.
- Remove tension strut on spring strut dome 51 71 373 - Removing and installing/replacing tension strut on spring strut dome.
- Remove fresh air duct Service and Repair.
Important!
Before fitting windshield wiper arms, allow wiper motor to run into rest position.
Release screws (1).
Installation:
Tightening torque 61 61 15AZ 61 61 Windshield Wipers.
Remove cross-strut bearing block (2) in direction of arrow.
Unfasten plug connection (1) and disconnect.
Release screws (A5...A1).
Installation:
Insert screws (A1...A5) in specified sequence until hand-tight.
To tighten down screw (A2), if necessary move complete wiper console linkage (2) into reversal position.
Tighten down screws (A1...A5) in specified sequence to tightening torque 61 61 6AZ 61 61 Windshield Wipers.
Lever out complete wiper console (2) in direction of arrow.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.