SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2008M5 (E60) V10-5.0L (S85)REPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWINDSHIELD WASHER PUMPSERVICE AND REPAIR
2008 BMW M5 (E60) V10-5.0L (S85)

Windshield Washer Pump: Service and Repair

2008 BMW M5 (E60) V10-5.0L (S85)SECTION Service and Repair



61 71 100 - Removing and installing/replacing windscreen washer pump





Necessary preliminary tasks:
- If necessary, remove left front wheel Removing or Installing Front or Rear Wheel
- Remove front underbody protection Removing and Installing / Replacing Front Underbody Protection





Note:
For purposes of clarity, illustration shows front wheel removed.

Release screws.

Fold back wheel arch trim (1) in direction of arrow.





Note:
Catch any escaping washer fluid if necessary.

Disconnect plug connection (1).

Detach hose (2) from windscreen washer pump (3).
Pull windscreen washer pump (3) in direction of arrow out of fluid reservoir for windscreen washer unit (4).





Installation:
- Replace strainer for windscreen washer pump.
- If necessary, coat sealing ring of windscreen washer pump with antiseize agent.
- Ensure hose is laid without kinks.
- Fill fluid reservoir
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.