Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2008M5 (E60) V10-5.0L (S85)REPAIR AND DIAGNOSISSTEERING AND SUSPENSIONSTEERINGTESTING AND INSPECTIONPROGRAMMING AND RELEARNING
2008 BMW M5 (E60) V10-5.0L (S85)
Programming and Relearning
2008 BMW M5 (E60) V10-5.0L (S85)SECTION Programming and Relearning
61 00 . - Version with AFS: setting steering angle (after reconnecting vehicle battery)
Note:
Version with AFS:
After reconnecting Instructions for Disconnecting and Connecting Battery the vehicle battery, carry out the following procedure for setting the steering angle:
- Start engine.
- Turn steering wheel left to full lock.
- Turn steering wheel right to full lock.
- Turn steering wheel to central position.
- Turn off engine.
- Turn on ignition (terminal 15), AFS telltale and Check Control message go out.
Note:
Entry in the fault memory remains unaffected by this procedure, therefore if necessary
- Connect diagnosis system
- Clear fault memory
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.