Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2008M5 (E60) V10-5.0L (S85)REPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMSTART / STOP SWITCHSERVICE AND REPAIR
2008 BMW M5 (E60) V10-5.0L (S85)
Start / Stop Switch: Service and Repair
2008 BMW M5 (E60) V10-5.0L (S85)SECTION Service and Repair
61 31 023 - Removing and installing/replacing Start/Stop switch
Special tools required:
- 00 9 341
Attach special tool 00 9 341 as illustrated.
Unclip Start/Stop switch with associated ribbon cable in direction of arrow.
Important!
Carefully unlock and disconnect associated plug connection for ribbon cable.
Replace the ribbon cable if damaged.
Remove Start/Stop switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.