SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2008M5 (E60) V10-5.0L (S85)REPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMIGNITION SWITCHSERVICE AND REPAIR
2008 BMW M5 (E60) V10-5.0L (S85)

Ignition Switch: Service and Repair

2008 BMW M5 (E60) V10-5.0L (S85)SECTION Service and Repair



61 31 020 - Removing and installing/replacing ignition starter switch





Necessary preliminary tasks:
- Move ignition lock to key position 0 (stop)
- Remove lower section of steering column trim Removing and Installing/Replacing Lower Section of Steering Column Trim





Important!
Before removing ignition starter switch (1), secure inner shaft against turning:
Insert a M2.5*8 screw in bore (2).

Installation:
Remove screw in bore (2).





Release screws (1), tightening torque 61 31 1AZ Specifications.

Installation:
Secure screws (1) with sealing paint.

Important!
Carefully unlock and disconnect associated plug connection for ribbon cable.
Replace the ribbon cable if damaged.
The ribbon cable leads to the control unit for the Car Access System Service and Repair.

Remove ignition starter switch (2).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.