Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removing and Installing/Replacing Fiber-Optic Cable Connector
2008 BMW M5 (E60) V10-5.0L (S85)SECTION Removing and Installing/Replacing Fiber-Optic Cable Connector
61 13 ... - Removing and installing/replacing fiber-optic cable connector
Important!
Comply with notes and instructions on handling fiber-optic cables 61 00 ... Notes on Handling Optical Fibers.
Necessary preliminary tasks:
E60:
- Remove luggage compartment trim on left side panel
E61:
- Remove luggage compartment wheel arch trim on left.
Insert a small screwdriver into openings (1).
Expand catches of cover (2) and remove cover (2) in direction of arrow.
Note:
Fiber-optic cables with locks at top can be removed directly.
Before the fiber-optic cables with locks at the bottom are removed, the fiber-optic cable connector (4) must be removed from the holder (3).
Removing a fiber-optic cable:
Lift lock (1) carefully and feed fiber-optic cable (2) out of connector (4).
Installation Note:
Make sure fiber-optic cable (2) is correctly engaged in fiber-optic cable connector (4).
Removing connector (2) from holder (3):
Release lock in bore (1) by pressing and remove fiber-optic cable connector (2) in direction of arrow from holder (3).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.