Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2008M5 (E60) V10-5.0L (S85)REPAIR AND DIAGNOSISRESTRAINTS AND SAFETY SYSTEMSAIR BAG SYSTEMSIMPACT SENSORSERVICE AND REPAIRREMOVING AND INSTALLING/REPLACING VEHICLE CENTER SENSOR
2008 BMW M5 (E60) V10-5.0L (S85)
Removing and Installing/Replacing Vehicle Center Sensor
2008 BMW M5 (E60) V10-5.0L (S85)SECTION Removing and Installing/Replacing Vehicle Center Sensor
65 77 730 - Removing and installing/replacing vehicle center sensor
Important!
Read and comply with notes on protection against electrostatic damage (ESD protection) 61 35 ... Notes on ESD Protection (Electro Static Discharge).
Warning!
Note airbag safety instructions! [1][2]Safety Regulations for Handling Components with Gas Generators
Incorrect handling can activate airbag and cause injury.
Note:
Follow instructions for handling optical fibers 61 00 ... Notes on Handling Optical Fibers.
Necessary preliminary tasks:
- Disconnect battery negative lead Instructions for Disconnecting and Connecting Battery and cover
- Remove center console 51 16 200 Removing and Installing Storage Compartment
Note:
Middle rear compartment ventilation duct shown removed for purposes of clarity.
Unfasten plug connection (1) and disconnect.
Release screws (2), tightening torque 65 77 6AZ Airbag Triggering Control.
Remove vehicle center sensor (3).
Replacement:
Carry out programming/coding Programming and Relearning.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.