Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removing and Installing/Replacing Front Left or Right Acceleration Sensor
2008 BMW M5 (E60) V10-5.0L (S85)SECTION Removing and Installing/Replacing Front Left or Right Acceleration Sensor
65 77 541 - Removing and installing/replacing front left or right acceleration sensor
Note:
Acceleration sensor only fitted in US version!
Necessary preliminary tasks:
- Remove front bumper trim 51 11 156 Removing and Installing Front Bumper Trim
Disconnect plug connection (1).
Release screws (2) and remove acceleration sensor (3).
Installation:
Tightening torque 65 77 9AZ Airbag Triggering Control.
Replace screws (2).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.