Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2008M5 (E60) V10-5.0L (S85)REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - ACCESSORIES AND OPTIONAL EQUIPMENTENTERTAINMENT SYSTEM CONTROL MODULESERVICE AND REPAIRREMOVING AND INSTALLING/REPLACING VIDEO MODULE FOR ON-BOARD MONITOR
2008 BMW M5 (E60) V10-5.0L (S85)
Removing and Installing/Replacing Video Module for On-Board Monitor
2008 BMW M5 (E60) V10-5.0L (S85)SECTION Removing and Installing/Replacing Video Module for On-Board Monitor
65 50 011 - Removing and installing/replacing video module for on-board monitor
Important!
Read and comply with notes on protection against electrostatic damage (ESD protection) 61 35 ... Notes on ESD Protection (Electro Static Discharge).
Necessary preliminary tasks:
- Disconnect battery negative lead Instructions for Disconnecting and Connecting Battery
- Remove luggage compartment trim on left side panel
Note:
Follow instructions for handling optical fibers 61 00 ... Notes on Handling Optical Fibers.
Release screws (1).
Remove storage compartment (2) in direction of arrow from holder (3).
Installation Note:
Do not mix up antenna connectors (1).
Mark antenna plugs (1) and disconnect.
Unfasten plug connection (2) and disconnect.
Release screws (3).
Remove video module for on-board monitor (4) in direction of arrow.
Replacement:
Release screws (1) and remove holder (2) from video module for on-board monitor (3).
Replacement:
Carry out programming/coding Programming and Relearning.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.