Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2008M5 (E60) V10-5.0L (S85)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULEDIAGRAMSDIAGRAM INFORMATION AND INSTRUCTIONSSIGNAL GLOSSARYSIGNAL NAMES WITH L
2008 BMW M5 (E60) V10-5.0L (S85)
Signal Names With L
2008 BMW M5 (E60) V10-5.0L (S85)SECTION Signal Names With L
LBV1BF Signal, seat-back width adjustment
LBV1FA Signal, seat-back width adjustment
LBV2BF Signal, seat-back width adjustment
LBV2FA Signal, seat-back width adjustment
LBVHMBF Seat back width, Hall sensor, ground
LBVHMFA Seat back width, Hall sensor, ground
LBVHSBF Seat back width, Hall sensor, signal
LBVHSFA Seat back width, Hall sensor, signal
LDP+BF Motor, lumbar support, plus
LDP+FA Motor, lumbar support, plus
LDP-BF Motor, lumbar support, minus
LDP-FA Motor, lumbar support, minus
LDV1BF Signal, valve 1, lumbar
LDV1FA Signal, valve 1, lumbar
LDV2BF Signal, valve 2, lumbar
LDV2FA Signal, valve 2, lumbar
LDV3BF Signal, valve 3, lumbar
LDV3FA Signal, valve 3, lumbar
LDV4BF Signal, valve 4, lumbar
LDV4FA Signal, valve 4, lumbar
LDV-BF Valve block, lumbar, minus
LDV-FA Valve block, lumbar, minus
LEDLA Automatic driving lights LED
LIN- Ground, LIN bus
LIN_ALC Signal, LIN bus
LIN_BUS Signal, LIN bus
LIN_DATA Signal, LIN bus
LIN_GEBL Signal, LIN bus
LIN_GND Ground, LIN bus
LIN+ Supply, LIN bus
LINV1_HL Supply, receiving antenna, rear left
LINV1_HR Supply, receiving antenna, rear right
LINV1_VL Supply, receiving antenna, front left
LINV1_VR Supply, receiving antenna, front right
LKS Signal, solenoid switch, radiator blind
LKV+BF Signal, seat-back head adjustment plus
LKV+FA Motor, seat back head, plus
LKV-BF Motor, seat back head, plus
LKV-FA Motor, seat back head, plus
LKVHMBF Seat back head, Hall sensor
LKVHMFA Seat back head, Hall sensor
LKVHSBF Seat back head, Hall sensor
LKVHSFA Seat back head, Hall sensor
LNV1BF Signal, seat-back angle adjustment, passenger
LNV1FA Signal, seat-back angle adjustment, driver
LNV2BF Signal, seat-back angle adjustment, passenger
LNV2FA Signal, seat-back angle adjustment, driver
LNVHMBF Seat back inclination, Hall sensor, ground
LNVHMFA Seat back inclination, Hall sensor, ground
LNVHSBF Seat back inclination, Hall sensor, signal
LNVHSFA Seat back inclination, Hall sensor, signal
LOBFM- Earth, motor, lumbar support, passenger
LOBFPP Lumbar support, passenger, pump
LOFAM- Ground, motor, lumbar support, driver
LOFAPP Lumbar support, driver, pump
LPPM Motor, secondary-air pump, plus
LS_BEL Light switch unit, illumination
LS_GND Light switch unit, ground
LS_NOTR- Signal, emergency call speaker -
LS_NOTR+ Signal, emergency call speaker +
LSPHL- Signal, speaker, rear left -
LSPHL+ Signal, speaker, rear left +
LSPHR- Signal, speaker, rear right -
LSPHR+ Signal, speaker, rear right +
LSPVL- Signal, speaker, front left -
LSPVL+ Signal, speaker, front left +
LSPVR- Signal, speaker, front right -
LSPVR+ Signal, speaker, front right +
LWBL Lamp in hazard-warning switch
LWR Signal, headlight beam height control
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.