Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Signal Names With D
2008 BMW M5 (E60) V10-5.0L (S85)SECTION Signal Names With D
D Signal, selector-lever position D
D_BSD Signal, bit serial data interface
D_EWS Signal, electronic immobilizer
D_TXD2 Signal, transmit data
D_WHL Signal, ultrasonic sensor
D_WHML Signal, ultrasonic sensor
D_WHMR Signal, ultrasonic sensor
D_WHR Signal, ultrasonic sensor
D_WVL Signal, ultrasonic sensor
D_WVML Signal, ultrasonic sensor
D_WVMR Signal, ultrasonic sensor
D_WVR Signal, ultrasonic sensor
DATA_RXD Data signal, telephone
DATA_TXD Data signal, telephone
DFA_CAS Speed-sensor output simulated
DFAHL Dynamic driving signal, rear left
DFAHR Signal, wheel-speed sensor, rear right
DFAVL Signal, wheel-speed sensor, front left
DFAVR Signal, wheel-speed sensor, front right
DFHR Wheel-speed sensor, rear right
DFHR+ Power supply, wh.-sp. sensor, rear right
DGR_1 Signal, brake pressure sensor
DGR_2 Signal, brake pressure sensor
DGR_5V Supply, brake pressure sensor
DIAG Signal, fan
DIAG_DKH Diagnosis signal, fuel heating
DIM Signal, dimmer light switch
DOSP Engine, fuel metering pump
DP_HL Signal, wheel-speed sensor, rear left
DP_HR Signal, wheel-speed sensor, rear right
DP_VL Signal, wheel-speed sensor, front left
DP_VR Signal, wheel-speed sensor, front right
DS_HL Signal, wheel-speed sensor, rear left
DS_HR Signal, wheel-speed sensor, rear right
DS_VL Signal, wheel-speed sensor, front left
DS_VR Signal, wheel-speed sensor, front right
DSA Signal, refrigerant pressure sensor
DSC_PASS Signal, DSC button
DSENS- Ground, sensors
DSENS+ Supply, sensors
DWAH Signal, tilt sensor, emergency power siren
DWAL LED, antitheft alarm system
DWG_31 Ground, angle-of-rotation sensor
DWG_IN Signal, angle-of-rotation sensor
DWG_OUT Signal, angle-of-rotation sensor
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.