Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2008M5 (E60) V10-5.0L (S85)REPAIR AND DIAGNOSISLIGHTING AND HORNSRELAYS AND MODULES - LIGHTING AND HORNSLAMP CONTROL MODULESERVICE AND REPAIR
2008 BMW M5 (E60) V10-5.0L (S85)
Lamp Control Module: Service and Repair
2008 BMW M5 (E60) V10-5.0L (S85)SECTION Service and Repair
61 31 037 - Removing and installing/replacing lighting control unit
Special tools required:
- 64 1 020 64 1 020 Release Hook
Attach special tool 64 1 020 64 1 020 Release Hook at openings (1) and lever out catches (2).
Pull back lighting control unit (3).
Unlock and disconnect associated plug connection, remove lighting control unit (3).
Installation:
Make sure clips (1) are correctly seated on trim of lighting control unit (2).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.