Replacing Drive/Electronics Box for Left Adaptive Headlight

2008 BMW M5 (E60) V10-5.0L (S85)SECTION Replacing Drive/Electronics Box for Left Adaptive Headlight



63 12 895 - Replacing drive/electronics box for left adaptive headlight





Important!
Read and comply with notes on protection against electrostatic damage (ESD protection) 61 35 ... Notes on ESD Protection (Electro Static Discharge).





Warning!
Version with xenon headlights: Danger to life due to high voltage! Therefore disconnect all components from voltage supply before removal.
Work on the entire xenon lighting system (ignition unit, control unit and lamp) may only be carried out by specialist personnel.





Necessary preliminary tasks:
- Remove left headlight Removing and Installing/Replacing Left Headlight (Xenon Headlight)





Release screws (1).
Remove drive/electronics box for adaptive headlight (2) from headlight (3).





Installation Note:
Fit drive/electronics box for adaptive headlight (1) exactly on headlight.
Make sure pin housing (2) is correctly seated in plug housing (3).





Carry out coding/programming Programming and Relearning.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.