Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2008M5 (E60) V10-5.0L (S85)REPAIR AND DIAGNOSISLIGHTING AND HORNSLICENSE PLATE LAMPSERVICE AND REPAIR
2008 BMW M5 (E60) V10-5.0L (S85)
License Plate Lamp: Service and Repair
2008 BMW M5 (E60) V10-5.0L (S85)SECTION Service and Repair
63 26 000 - Removing and installing/replacing left or right license plate light
Special tools required:
- 64 1 020 64 1 020 Release Hook
Slide license plate light (1) in direction of arrow slightly and lever out with special tool 64 1 020 64 1 020 Release Hook.
Unlock plug connection underneath and disconnect.
Remove license plate light (1).
Warning!
Follow instructions for handling light bulbs (exterior lights) Instructions for Handling Light Bulbs (Exterior Lights).
Replacement:
If necessary, remove bulb.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.