Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2008M5 (E60) V10-5.0L (S85)REPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLDISC BRAKE SYSTEMBRAKE PADTESTING AND INSPECTION
2008 BMW M5 (E60) V10-5.0L (S85)
Brake Pad: Testing and Inspection
2008 BMW M5 (E60) V10-5.0L (S85)SECTION Testing and Inspection
34 00 010 - Checking thickness of brake pad
Special tools required:
- 34 1 260 34 1 260 Brake Lining Measuring Gauge
Note:
The thickness of the outer brake pads can be determined without removing the wheels.
If necessary, move car until opening for brake pad wear indicator (brake pad) can be seen through rim styling.
Insert special tool 34 1 260 34 1 260 Brake Lining Measuring Gauge through rim into opening for brake pad wear indicator.
Press special tool onto brake pad. Slide ring (1) in direction of arrow up to stop and read off measured value.
Note:
(A) Brake disk
(B) Brake pad with backplate
Safe limit for lining wear, front brake [1][2]34 11 Front Brake.
Safe limit for lining wear, rear brake [1][2]34 21 Rear Brake.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.