Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removing and Installing/Replacing DSC Sensor
2008 BMW M5 (E60) V10-5.0L (S85)SECTION Removing and Installing/Replacing DSC Sensor
34 52 550 - Removing and installing/replacing DSC sensor (S85)
Important!
Read and comply with notes on protection against electrostatic damage (ESD protection) 61 35 ... Notes on ESD Protection (Electro Static Discharge).
Necessary preliminary tasks:
- Remove right front seat Removing and Installing Left or Right Front Seat
- Remove front inside entrance cover strip 51 47 000 Removing and Installing/Replacing Front (Inside) Left or Right Entrance Cover Strip
Lift carpet (1) and fold to side.
Release screws (2) and swing out DSC sensor (3).
Installation Note:
Tightening torque 34 51 3AZ 34 51 Slip Control System (ABS, ASC+T, DSC).
Unlock plug connection (1) and remove DSC sensor (2).
Installation Note:
Make sure plug connection locks correctly.
Carry out calibration/adjustment of DSC sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.