Removing and Installing/Replacing Lock for Left or Right Rear Seat Backrest (Through-Loading System)

2008 BMW M5 (E60) V10-5.0L (S85)SECTION Removing and Installing/Replacing Lock for Left or Right Rear Seat Backrest (Through-Loading System)



52 26 311 - Removing and installing/replacing lock for left or right rear seat backrest (through-loading system)





Unlock and fold back rear seat backrest.

Note:
If the rear seat backrest cannot be unlocked, carry out emergency opening Emergency Actuator for Rear Seat Backrest.

Unclip Bowden cable from holders (1).
Release screws (2).
Tightening torque: 52 26 10AZ Rear Seats (Through-Loading System).





Feed lock (1) out of installation opening slightly and unclip Bowden cable (2).
Remove lock completely from installation opening.

Installation:
Catches (2) on lock must not be damaged.
Bowden cable must be correctly anchored in catches (2).





Installation:
Slide guide lug (1) of lock into opening (2).





Note:
Adjustment of lock:
- Slacken screws
- Firmly push engaged backrest back
- Tighten down screws
Tightening torque: 52 26 10AZ Rear Seats (Through-Loading System).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.